Setting Entry And Exit Points - Brother BES-100E Workbook

NOTE: After splitting a manual stitch, stitches should be inserted to form lock stitching in order to prevent
the stitching from unraveling. For more information about inserting manual stitches, see chapter
20.

Setting entry and exit points

To specify the punchpoint where sewing of the design shape begins or ends:
1
Using the
Reshape
selected punchpoint changes to light blue.
NOTE: For regions and polygons, any punchpoint throughout the shape can be set as an entry or exit
point. However, for columns and paths, only end points (which appear in red) can be set as entry
and exit points.
For more information about using the buttons in the
Navigating through the design in chapter 23.
2
On the
Punchpoints
for the design shape) or click
shape).
58
tool ( ), select the punchpoint of the manual stitch that you wish to split. The
drop-down menu, click
Set Exit Point
Figure 97
Navigation
(to specify the punchpoint as the beginning stitch
Set Entry Point
(to specify the punchpoint as the final stitch for the design
palette to select punchpoints, see