1. Manuals
  2. Brands
  3. Fluke Manuals
  4. Security System
  5. 1060AM-NM-LRVAR Operators
  6. Operator's manual

Fluke 1060AM-NM-LRVAR Operator's Manual

Local, remote, and flasher alarms
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
1060AM-NM-LRVAR
Local, Remote, and Flasher Alarms
Operators Manual
March 2005
Manual No. 1060AMNMLRVAR-1 Rev. 1
©2004, 2005 Fluke Corporation, All rights reserved. Printed in U.S.A.
All product names are trademarks of their respective companies

Advertisement

Table of Contents
loading

Summary of Contents for Fluke 1060AM-NM-LRVAR

  • Page 1 1060AM-NM-LRVAR Local, Remote, and Flasher Alarms Operators Manual March 2005 Manual No. 1060AMNMLRVAR-1 Rev. 1 ©2004, 2005 Fluke Corporation, All rights reserved. Printed in U.S.A. All product names are trademarks of their respective companies...
  • Page 2 Fluke Biomedical Radiation Management Services 6045 Cochran Road Cleveland, Ohio 44139 440.498.2564 www.flukebiomedical.com/rms...

  • Page 3: Table Of Contents

    Table of Contents Section 1: Introduction....................1-1 Procedures, Warnings and Cautions ............1-1 Section 2: Instructions ....................2-1 General Description ..................2-1 Specifications....................2-1 Receiving Inspection..................2-2 Storage ......................2-2 Installation....................2-3 Electrical Interface ..................2-4 Operation ..................... 2-5 Section 3: Maintenance and Cleaning................
  • Page 4 (Blank Page)

  • Page 5: Introduction

    WARNINGS and CAUTIONS are heeded. Failure on the part of the owner or user in any way to follow the prescribed procedures shall absolve Fluke Biomedical and its agents from any resulting liability.
  • Page 6 1060AM-NM-LRVAR Operators Manual (Blank Page)

  • Page 7: Instructions

    2.1 General Description Refer to 1060-005 drawing located in Appendix A . The Fluke Biomedical local , remote , and flasher alarms are used in conjunction with the Victoreen Model 1060AM-NM-LR. The operating range of this system is 0.01 mR/hr to 1R/hr.

  • Page 8: Receiving Inspection

    If any of the listed items are missing or damaged, notify Fluke Biomedical. 2.4 Storage Storage of Fluke Biomedical instruments must comply with Level B storage requirements as outlined in ANSI N45.2.2 (1972) Section 6.1.2(.2). The storage area shall comply with ANSI N45.2.2 (1972) Section 6.2 Storage Area, Paragraphs...

  • Page 9: Installation

    Instructions Installation 2.5 Installation WARNING To prevent electrical shock, ensure that power is disconnected before installing the alarms Installation of the 1060am-nm-lrvar consists of mounting the unit , providing an electrical interface , and performing an operational check. The 1060-024,1060-034, and 1060-026 have four mounting holes inside each chassis with a 0.19 diameter clearance.

  • Page 10: Electrical Interface

    1060AM-NM-LRVAR Operators Manual 2.6 Electrical interface The Local alarm (1060-024) requires power connections as follows: (See appendix A for the 1060-13 and 1060-024 drawings) Terminate the input power to TB2-1(L1) of the Local alarm assembly at the end of this installation . 1.

  • Page 11: Operation

    Instructions Operation 2.7 Operation The red beacons and red leds are ON . The flasher alarm is blinking . Connect the free end of the I/O (1060ds-24) cable to the model 1060AM-NM-LR I/O connector. Connect the 1060AM-NM-110 (12 volt 500 mA) power cube connector to the 1060AM- NM-LR power input .
  • Page 12 1060AM-NM-LRVAR Operators Manual (Blank Page)

  • Page 13: Maintenance And Cleaning

    Maintenance Maintenance and Cleaning Section 3 Maintenance and Cleaning WARNING To prevent injury, do not remove or insert lamp when unit is energized . CAUTION To prevent damage to the lens, do not use abrasive materials or cleaners Refer the parts lists for the required type of lamp After disconnecting power, replace the lamp as follows: 1.

  • Page 14: Troubleshooting

    Refer to Appendix A for drawings and parts lists. • If a problem cannot be resolved using the drawings in the Appendix while applying the troubleshooting instructions found in this manual, please contact Fluke Biomedical at 440.248.9300 for assistance.

  • Page 15: Appendix A: Applicable Drawings And Parts List

    Appendix Applicable Drawings and Parts List Appendix A Applicable Drawings and Parts List 4.1 Applicable Drawings and Parts List 1060-005 Main Assembly 1060-005 Main Assembly Parts List 1060-010 Alarm PCB Assembly 1060-010 Alarm PCB Parts List 1060-013 Local Alarm Schematic 1060-024 Local Alarm Assembly 1060-024...
  • Page 16 Fluke Biomedical Radiation Management Services 6045 Cochran Road Cleveland, Ohio 44139 440.498.2564 www.flukebiomedical.com/rms...

Table of Contents