Advertisement
FRONT WHEEL
TOE-IN
ADJUSTMENT
Front wheel toe-in is required for proper
steering operation.
Toe-in was set at the
factory and adjustment should not be nec-
essary. If parts in the front axle or steering
mechanism
have been replaced
or dam-
aged, check toe-in and adjust if necessary.
TO CHECK TOE-IN
• Position front wheels straight ahead.
• Measure
distance between wheels at
front and rear of tires (dimensions "A"
and "B").
• Front dimension "A" should be 1/8" to
1/4" less than rear dimension =B".
TO ADJUST TOE-IN
• Loosen jam nuts at adjustment sleeves
on tie red.
• Adjust tie red until dimension "A" is 1/8"
to 1/4" less than dimension "B".
• Tighten jam nuts securely.
_Adius ent
/_
Sleeves
Jam Nuts"
_._
FRONT
WHEEL
CAMBER
The front wheel camber
is not adjustable
on your tractor.
If damage has occurred to
affect the front wheel camber, contact your
nearest authorized service center/depart-
ment.
TO REMOVE
WHEEL
FOR REPAIRS
• Block up axle securely.
• Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheel contains a square key - Do not
lose).
• Repair tire and reassemble.
• On rear wheels only: align grooves in
rear wheel hub and axle.
Insert square
key.
• Replace washers and snap retaining
ring securely
in axle: groove.
• Replace axle cover
Washers_
Retaining
A
f__'_
Riog
\ / .11¢ .111
Square Key
(Rear Wheel Only)--
NOTE: To seal tire punctures
and prevent
flat tires due to slow leaks, tire sealant
may be purchased
from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
28
TO START ENGINE WITH A WEAK
BATTERY
ACAUTION:
Lead-acid batteries gener-
ate explosive gases.
Keep sparks, flame
and smoking matedals away from batter-
ies. Always wear eye protection when
around batteries.
If your battery is too weak to start the
engine, it should be recharged.
(See "BAT-
TERY" in the MAINTENANCE
section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor Is equiped with
a 12 volt negative grounded system. The
other vehical must also be a 12 volt nega-
tive grounded system. Do not use your
tractor battery to start other vehicles.
TO ATTACH JUMPER
CABLES
-
• Connect each end of the RED cable to
the POSITIVE
(+) terminal of each bat-
tery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE
(-) terminal of fully
charged battery.
• Connect the other end of the BLACK
cable to good CHASSIS
GROUND,
away from fuel tank and battery.
"Positive"___"Negative"
(*)
"
"
(')
[
LaHne/I _ __
Advertisement
