Advertisement
REASSEMBLE
HEIGHT
INDICATOR
(If
equipped)
(See Fig. 19)
1.
Reassemble previously removed height indicator
adding two spacer washers and replacing old hex
bolt with the 5/16-18 x 1-1/4 hex bolt provided with
this kit.
2.
Ensure height indicator is showing correct position of
deck. This may be adjusted after final assembly of
deck by loosening the hex bolt and moving height
indicator to correct position in relation to deck, then
retighten hex bolt and replace snap-out cover.
Assemble all parts in order shown.
HEIGHT
INDICATOR
FLAT
WASHER
\
LOCK
WASHER
NEW HEX
ADO SPACER
FLAT
WASHER
FIG. 19
REASSEMBLE
TRACTOR
•
Reinstall rear wheel and mower deck, if removed
earlier.
•
Remove wood block.
•
Reconnect spark plug wire(s).
•
Retighten lift assist spring bolt.
OPERATION
AND MAINTENANCE
Make sure all bolts and nuts are tight and retainer
springs are secure.
CAUTION:
Read
the Safety
Rules
I
carefully before operating your Electric
Actuator.
1.
Ignition switch must be "ON" to operate electric lift
actuator.
2.
After you install lift switch follow markings already on
dashboard.
3.
If you hear a ratcheting sound, you know you are
fully raised or fully lowered. Release switch promptly
after ratcheting begins.
iA CAO O.I
ground when turning corners, reversing
or transporting.
NOTE: The electric actuator is equipped with an over-
load circuit that will trip when overloaded. Unit will
automatically
reset after 10 seconds.
LUBRICATION
1.
The Electric Actuator is lubricated for normal life. If
Actuator is disassembled for repair, upon
reassembly lubricate with high performance extreme
pressure lubricating grease.
2.
Apply a light coat of grease to threaded areas and
pivot points.
12
Advertisement
