General Recommendations - Craftsman 358.798980 Operator's Manual

NOTE: If the engine sounds as if it is
trymg to start before the 5th pull, go
to the next step.
• Move choke to HALF position.
• Pull starter rope sharply until engine
runs, but no more than 6 pulis.
NOTE: If engine has not started after 6
pulls, repeat all of the above steps.
, Allow engine to run for 15 seconds,
then move choke to OFF position.
• Squeeze and release the throttle trig-
ger to allow engine to idle.
NOTE: If engine dies wdh choke at OFF
position, move the choke to the Half
position and pull the starter rope 6
more times. If engine does not start
and operate properly, refer to "Carbure-
tor Adjustments."
• To stop eng=ne, move switch to OFF.
FOR A WARM ENGINE
• Move switch to the ON position.
• Move choke to OFF position.
• Activate the throttle lock.
• Press primer bulb 6 times.
• Sharply pull starter rope until engine
runs.
NOTE: If engine does not run after 5
pulls, it is probably flooded. Wait a few
minutes and repeat procedure with
choke at OFF.
• To stop engine, move switch to OFF.
DIFFICULT STARTING OR
STARTING A FLOODED ENGINE
Flooded engines can be started by
placing choke lever in the Off Choke
position and On/Stop switch in the On
position. Activate the throttle lock; then,
pull rope until engine starts. After the
engine starts, squeeze and release the
throttle trigger to allow engine to idle.
Starting could require pulling the starter
handle many times depending on how
badly unit is flooded. If unit still doesn't
start, refer to the TROUBLESHOOTING
chart or call 1-800-235-5878.
CUSTOMER RESPONSIBILITIES
] CARE & MAINTENANCE TASK
i Check lot Loose fasteners and parts
t Check for damaged or worn parts
I Clean unit and labels
[ Clean air tilter
Replace spark plug
GENERALRECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive full value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically to
WHEN TO PERFORM
Before each use
Belore each use
After each use
Every 5 hours of operation
Yearly
Make sure engine stops; then restart
engine and continue.
• Fuel Tank - Discontinue use of unit if
fuel tank shows signs of damage or
leaks.
• Vacuum Bag - Discontinue use of
vacuum bag if it is torn or damaged.
CLEAN UNIT & LABELS
propedy maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
- Spark Plug Boot
• Air Filter
• Housing Screws
CHECK FOR DAMAGED OR
WORN PARTS
Refer replacement of damaged/worn
parts to your Sears Service Center.
• On'Stop Switch - Ensure On/Stop
sw_tch functions properly by moving
the swntchtO the "Stop" position.
• Clean the unit using a damp cloth
with a mild detergent,
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
Do nol clean filter in gasoline or other
flammable solvent. Doing so can
create a fire hazard or produce harmful
evaporative emissions.
Cleaning the air filter:
A dirty air filter decreases engine per-
Iormance and increases fuel consump-
tion and harmful emissions. Always
clean after every 5 hours of operation.
-7-