Set Up; Before You Begin; After Cleaning - Eureka 2590 Series Owner's Manual

●
I
10
ENGLISH
SET-UP
IMPORTANT: For best results, begin with a clean surface by
Note: Familiarize yourself with the parts of the extractor by reading
Step 1: Fill Shampoo Bottle
Step 2: Fill Clean Water Tank
Note: When moving the extractor from one location to another,

Before You Begin

A. Vacuum Carpet
FIG. 1
B. Pretest for Color Fastness. Before cleaning the carpet, we
C. Remove Furniture. Remove as much furniture from the room as
●
K

After Cleaning

• Allow carpets to dry thoroughly. Try to keep children and pets off the
• Use towels or white cloths to step on if you must walk on the area
• Wipe cleaning solution from woodwork and wood furniture immediately
• If furniture must be placed back in the room before the carpet is dry,
FIG. 2
vacuuming surface or item before using the extractor.
this owner's manual before using.
●
I
(Fig. 1). If handle is folded, lift handle to
operating position.
a) Lift up and pull out the shampoo bottle, fill with Eureka
Carpet & Upholstery Concentrate only.
b) Close cap tightly, and replace shampoo bottle.
c) Firmly push until the shampoo bottle snaps into place.
●
K
a) Lift up and pull out clean water tank.
b) Fill tank to the designated fill line with hot tap water (not
boiling), replace cap.
c) Firmly push until the clean water tank snaps back into position.
always make sure the recovery and clean water solution tanks
are completely empty. Then tilt the unit slightly backward and
roll on rear wheels, fold the looped handle and use the
carrying handle for transporting up and down stairs.
Note: Never use this extractor as a standard vacuum cleaner.
For best results, vacuum carpets with a vacuum cleaner that has an
agitator. The bristles of the agitator help loosen and remove soil that is
deep in the carpet nap.
recommend testing the carpet for color fastness. Moisten a white
towel with the cleaning solution. Test a small hidden area of the carpet
in a closet or in a corner. Gently rub the cloth over the carpet. Check
each color. If the towel does not pick up any color, it should be safe to
use the cleaning solution on the entire area.
possible. Place aluminum foil or plastic film under or around the legs
and bases of the remaining furniture to prevent stains. Leave the foil
or plastic in place until the carpet is completely dry. Use masking tape
or pins to hold furniture skirts and draperies up out of the way.
carpet until it is completely dry.
before it is dry.
to prevent damage to the wood or upholstery.
use aluminum foil or plastic under the furniture legs to prevent staining
the carpet.
(Fig. 2).