Table of Contents
Advertisement
Quick Links
For location of nearest
Eureka Warranty Station
or service information call
1-800-282-2886.
Vacuum Cleaner
Owner's Guide
790 Series
Index
Important Safeguards .................. 2
General Information ..................... 4
Dust Cup ..................................... 8
Exhaust Filter ............................ 10
Brush Roll .................................. 11
Brush Roll Belt ........................... 11
Warranty ............................... 15-16
Household Type
www.eureka.com
Advertisement
Table of Contents
Related Manuals for Eureka 790 Series
Summary of Contents for Eureka 790 Series
-
Page 1: Table Of Contents
General Information ..... 4 Use ..........5 Dust Cup ........8 Exhaust Filter ......10 Brush Roll ........11 Brush Roll Belt ......11 Warranty ....... 15-16 For location of nearest Eureka Warranty Station or service information call 1-800-282-2886. www.eureka.com... -
Page 2: Important Safeguards
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. •... - Page 3 CONSEILS DE SÉCURITÉ Lors de l’utilisation d’un appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: • Ne pas utiliser à...
-
Page 4: General Information
Mexico: 5670-6169 Canada: 1-800-282-2886 If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA. In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka Warranty for complete service information. -
Page 5: How To Use
HOW TO USE HANDLE RELEASE 3 POSITION ON/OFF SWITCH Power Switch Top position is Off. Middle position is for floor cleaning and cleaning with accessories (brush roll does not turn). Bottom position is for cleaning carpets (brush roll turns). Handle Release When handle is in collapsed position, press handle release button and rotate handle into upright position. - Page 6 HOW TO USE Cord Retainer When preparing to use vacuum, firmly push the electrical cord down into the cord retainer. This will place the electrical cord out CORD of the way while you vacuum. RETAINER HANDLE Handle Collapse Button COLLAPSE To collapse the handle from the BUTTON upright position, press handle...
-
Page 7: How To Use Accessories
HOW TO USE ACCESSORIES Dusting Brush Crevice Tool Collapse the handle from the upright position. Press handle release button and rotate handle down and against the body of the cleaner until it locks onto the body. The dusting brush fits on both the hose and the wand with a built-in crevice tool. -
Page 8: Dust Cup
HOW TO MAINTAIN How to Empty Dust Cup NOTE: Turn off the switch and unplug the electrical cord before servicing the cleaner. Never operate the vacuum cleaner without the dust cup or filter. FOR INSTRUCTIONS ON HOW TO REMOVE THE DUST CUP FROM THE CLEANER BODY, REFER TO PAGE 8. - Page 9 HOW TO MAINTAIN (continued) The instructions given in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust cup, filter, belt, and brush roll often. Empty the dust cup if it is full; clean the filter, replace the belt if it is stretched or cracked, and clean the brush roll bristles if they are wrapped with thread and hair.
-
Page 10: Exhaust Filter
Press the filter down on narrow pegs in the center of the grille. Replace the grille on the cleaner and replace the dust cup. Lower Filter Retainers Exhaust Grille Handle GENUINE Look for the symbol. EUREKA PRODUCT... -
Page 11: Brush Roll
HOW TO MAINTAIN (continued) NOTE: Turn off the switch and unplug the electrical cord before servicing the cleaner. REPLACE BRUSH ROLL BELT Remove the 10 screws on the bottom of the power nozzle. Flip the power nozzle back upright and remove the hood. - Page 14 ©2003 White Consolidated, Ltd. Part No. 72806 Printed in China (02/03)