Craftsman 917.252530 Owner's Manual page 8

....... H
While battery is standing (after adding acid) and faterl while
battery is being charged, continue with assembly of tractor.
IMPORTANT: TO MAXIMIZE THE LIFE OF YOUR
BATTERY, IT fS NECESSARY THAT THE BATTERY BE
CHARGED BEFORE USE. FAILURE TO CHARGE
BATTERY CAN RESULT iN A SHORTENED BATTERY
LIFE.
Charge battery at a rate of 6 amperes for I hour. Use
a 12 volt battery charger. Observe all safety precau-
t{ons required for battery charging.
Checkthe acid level after the battery is charged. If the
acid has fallen below the correct level, add distilled or
iron free water.
Install the vent caps to cover the vent wells. Wash the
top of the battery with water to remove any acid, then
:wipe dry.
Check battery case for leakage to make sure that no
damage has occurred in handling.
Dispose of excess battery acid. Neutralize acid for
disposal by adding it to two gallons of water in a five
gallon plastic container. Stir with a wooden or plastic
paddle while adding baking soda until the addition of
more soda causes no more foaming,
Follow instructions on how to install battery.
SEAT PAN
i, VENT WELL
LEVEL
BATFERY
o
FIG. 2
CUT AWAY VIEW
FIG. 3
Ly_ •
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
• Remove cardboard packing on seat pan.
• Place seat on seat pan and assemble shoulder bolt.
• Assemble adjustment bolt, lock washerand flat washer
loosely. Do not tighten.
• Tighten shoulder bolt securely.
o Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached wh{ch
allows you to press clutch/brake pedal all the way
down.
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment bolt securely.
BOLT
FIG. 4
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
• Reduce tire pressure to PSi shown in "PRODUCT
SPECIFICATIONS" on page 3 of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properfy
leve]ed. See '%0 LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
section Of this manual. Verify that the belts are routed
correctly.
CHECK BRAKE SYSTEM
After you learn how to operate you r tractor, check to see that
the brake iS properly adjusted. See '%0 ADJUST BRAKE"
in the Service and Adjustments section of this manual.