Care And Cleaning; Customcool - GE 23 Owner's Manual And Installation

About CustomCoolY ge.com
How it Works
The CustomCool
TM
feature
is a system of
dampe_, a tim, a temperature thermistor
and a heater. Depending on the fllncfion
selected, a combination at these will be
used to quickly chill items, thaw items or
hold the pan at a specific temperature.
The pan is tightly sealed to prevent the pen's
temperature fl'om causing temperature
fluctuations in the rest of the refl_igeratm:
Some
CustomCool models
teature a beverage
centei; It is designed to store beverages at
colder temperatures, Select the Beverage
Center pad if you like to kee I) extra-chilled
refl'eshments on hand.
The controls _/r this pan are located at the
top of the refl_igerator with the temperature
conti'ols.
ExpressThaw
TM
ExpressChfll
TM
How to Use
0 Erupt}, the pan. Place the (;hill/Thaw
tra) in the pan. Place the items on the
tra) and close the pan completely,
@ Select the ExpressThaw_,"ExpressChill"
or SelectTemf" pad. The display and
SK/'light will coine on. Tap the pad
until the light appeais next to the
desired setting. Use the chart to
detemfine the best setting to use.
_:_ To stop a feature before it is
finished, tap that teature's pad
until no options are selected and
the display is off.
iJi:: During ExpressThaw and
ExpressChill,the displa)on tl_e
controls will count down the time
in the cycle.
_: _dter the ExpressThaw cycle is
complete, the I)an will reset to the
MEATsetting (32°F) to hel I) preserve
thawed items until they are used.
_: The displayed actual temperature (ff
the CustomCoolpan may wm' slightly
ti'om the SETtemperature based on
usage and operating enviromnent.
NOTE."For food safety reasons,it is recommended
that foods be wrapped in plastic wrap when using
ExpressThaHz This will help contain meat juices
and improve thawing performance.
How to Remove and Replace the Drawer
Toremove:
@ Pull the drawer out to the stop position.
@ Rotate all fore" swing locks to the unlock
position.
i,ifl the ti'ont (ff the drawer up and ()tit.
Toreplace:
@ Make sure all four swing locks are in the
unlock position.
Place the sides of the drawer into the
drawer supports, making sure the swing
locks fit on the drawer
slots.
I,ock all four s_dng hicks by rotating
them to the hick I)osition.