Samsung RFG297AA User Manual page 20

.
.
Remove the filter cap and insert the filter into the filter
housing.
Slowly turn the water filter 90 ° clockwise to align with the
printing mark on the cover, locking the filter in position.
Make sure to align the water filter label mark with center of
cover filter printing as illustrated. Remember, do not over-
tighten.
i /
/z ¸
Separation
of red cap,
Cover filter,
®
Turn until the label
aligned,
_You should remove the right side upper glass shelf before installing water filters.
Removing any residual matter inside the water supply line
after installing the water filter.
1. Turn ON the main water supply & turn OFF the valve to the water supply
line.
2. Run water through the dispenser until the water runs clear (approx. 6-
7minutes). This will clean the water supply system and remove air from the
lines.
3. Additional flushing may be required in some households.
4. Open the Refrigerator door and make sure there are no water leaks coming
from the water filter.
®
Be sure to flush the dispenser thoroughly or water may drip from the dispenser.
This is due to the fact that there is still air in the line.
20 Setti-_g Up