Enterasys 2S4082-25-SYS Hardware Installation Manual page 23

Overview
The NAC Controller PEP receives power and backplane connectivity when it is inserted into a
chassis.
Management of the module can be either In‐Band or Out‐Of‐Band. In‐Band remote management
®
is possible using Telnet, Enterasys Networks' NetSight management application, or WebView™
application. Out‐of‐band management is provided through the RJ45 COM (Communication) port
on the front panel using a VT100 terminal or a VT100 terminal emulator.
Enterasys Networks' HTTP‐based Web management application (WebView) is an intuitive web
tool for simple management tasks.
The CLI commands enable you to perform more complete switch configuration management
tasks.
For CLI command set information and how to configure the module, refer to the Enterasys Matrix
DFE‐Diamond/Platinum Series Configuration Guide.
There are 24 10/100/1000 ports and 2 SFP ports that support MGBICs for a total of 26 ports on the
2S4082‐25. There are 20 SFP ports on the 7S4280‐19 NAC Controller PEP. For additional
information on these ports, refer to Appendix A.
Enterasys NAC Controller Hardware Installation Guide 1-3