Calibrating With Colorwise Pro Tools And Autocal, Or Colorcal - Fiery KM-C2230 Color Manual

2
2-27 Using AutoCal and ColorCal
AutoCal is provided for compatibility with earlier Fiery X3e servers. You can perform
AutoCal or ColorCal calibration from either ColorWise Pro Tools or the Fiery X3e
Control Panel. For troubleshooting during the AutoCal procedure, see the
Management
To calibrate using AutoCal or ColorCal, you will need the Kodak Gray Scale
N :
OTE
strip included in the customer media pack that came with your Fiery X3e. You also
need the Kodak Gray Scale strip and Kodak Color Control Patches strip to calibrate
the scanner of the copier/printer for ColorCal.

Calibrating with ColorWise Pro Tools and AutoCal, or ColorCal

When you run ColorCal from ColorWise Pro Tools, you have the option to calibrate
the copier/printer's scanner before calibrating the Fiery X3e itself. This option is not
available for AutoCal. It is recommended to calibrate the scanner for ColorCal when
the copier/printer output has been adjusted, such as after maintenance or service.
The instructions for ColorCal refer to the document feeder (DF) on the copier
N :
OTE
as the scanner.
T C
O CALIBRATE WITH OLOR
1. Start ColorWise Pro Tools (on your Mac OS or Windows computer).
2. Start Calibrator.
For instructions on starting Calibrator, see
3. In the Select Measurement Method pane, choose AutoCal or ColorCal.
4. In the Check Print Settings pane, choose the desired Media.
If more than one option appears, choose the appropriate calibration set for the type of
media you will use most often.
For this calibration to take effect, the calibration set must be associated with an
N :
OTE
output profile. If you choose the default calibration set, you do not need to make a
new association. The default calibration set is already associated with the default
output profile.
5. Click Print in the Generate Measurement Page pane.
Guide.
W P T A
ISE RO OOLS AND UTO
C , C C
AL OR OLOR AL
page 2-6.
Job