Using Network Features; Displaying The Control Window Of The Projector With A Web Browser - Sony VPL-DW125 Operating Instructions Manual

B Network

Using Network Features

Connection to the network allows you to operate the following features:
• Checking the current status of the projector via a Web browser.
• Remotely controlling the projector via a Web browser.
• Receiving the e-mail report via the projector.
• Making the network settings for the projector.
• Supports network monitoring, control protocol (Advertisement, PJ Talk, PJ Link, AMX
DDDP [Dynamic Device Discovery Protocol]), Crestron RoomView.
Notes
• The menu displays used for the explanation below may be different depending on the model you
are using.
• Supported Web browsers are Internet Explorer 6/7/8.
• The menu displays only in English.
• If the browser of your computer is set to [Use a proxy server] when you access to the projector
from your computer, click the check mark to set accessing without using a proxy server.
Displaying the Control Window of the Projector with a Web
Browser
1
Connect the LAN cable.
LAN cable
(straight type)
(not supplied)
Hub, router, etc
2
Set the network settings for the
projector using "LAN Settings" on the
Connection/Power menu (page 24).
3
Start a web browser on the computer,
enter the following in the address field,
then press the Enter key on your
computer.
http://xxx.xxx.xxx.xxx
(xxx.xxx.xxx.xxx: IP address for the
projector)
28
Using Network Features
LAN Connector
You can confirm the IP address of the
projector in the "LAN Settings" on the
Connection/Power menu (page 24).
The following window appears in the
Web browser:
Once you make the network settings,
you can open the Control window only
by performing step 3 of this procedure.