Electrolux EWB 85100 W User Manual page 9

UNPACKING
1
2
UNTYING
A B
C
D
2 B
1
1
2
C
1
To install your washing machine at the
same level as surrounding furniture, pro-
ceed as shown on picture D.
WATER SUPPLY
Install the supplied water inlet hose at the
rear of your washing machine by proceed-
ing as follows. Do not reuse an old hose.
The water inlet hose can not be extended. If
it is too short, please contact the after-sales
service.
Open the water inlet tap. Check there are
no leaks.
DRAINAGE
A
Fit the U-piece on
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
1
ter the end of the
hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If
it is too short, contact an engineer.
2
ELECTRICAL CONNECTION
This washing machine must only be con-
nected in single-phased 230 V. Check the
fuse size: 10 A for 230 V. The appliance
D
must not be connected with an extension
lead or multi-plug adaptor. Ensure that the
plug is earthed and that it is in accordance
with current regulations.
POSITIONING
Position the appliance on a flat and hard
surface in a ventilated location. Ensure the
appliance does not come into contact with
the wall or other furniture.
To move your appliance, proceed as fol-
lows:
Place it on its rollers
by pulling the lever
located at the base
of the appliance hard
from right to left.
Once the appliance
is in the desired po-
sition, push the lever
back to its original
position. Accurate
90 90 90
O O O
electrolux 9
min
max
70 cm
100 cm