Electrolux LAVAMAT 42230 ELECTRONIC User Instructions page 24

User's instructions
Changing the spin speed
The spin speed can still be changed or the RINSE HOLD position
while the programme is running.
1. Press the START/PAUSE pushbutton
2. Change the spin speed with the Spin Speed/RINSE HOLD pushbutton.
3. Press the START/PAUSE pushbutton
continues.
Washing cycle complete/removing the washing
Once a washing programme cycle ended, the END light
on the Programme Progress Display.
If RINSE HOLD position
DOOR and END
" "
1. After a Rinse Hold, the water must first be drained:
– Either turn the programme selector to the OFF position " ", then turn
it to the DRAIN programme
(the water is drained without spinning),
" "
or
– turn the programme selector to the OFF position " ", then turn it to the
SPIN programme and press the START/PAUSE pusbutton
drained and the washing given a spin. The spin speed can also be changed
during the spin cycle).
When this stage of the programme is completed, the END light
illuminates.
2. Open the door.
The door can be opened after the DOOR light
" "
light has come on.
3. Remove the washing.
4. Turn the programme selector to the OFF position " ".
5. Close the water tap.
6. Leave the drum and the lid open to air the washing machine.
Important! If the washing machine is not to be used for a long period,
close the water tap and disconnect the washing machine from the
electricity mains.
24
.
" "
again. The washing programme
" "
" "
was selected, the indicator lights beside the
" "
lights illuminate.
" "
and press the START/PAUSE pushbutton
" "
" "
illuminates
(the water is
" "
goes off and the END
" "
set,
" "