Electrolux EWF 127570W User Manual page 6

6 electrolux
Display
The display shows the following information:
2.1: Temperature value
2.2: Temperature icons
During the washing cycle the display shows
the temperature icon animated to indicate
that the appliance has started the heating
phase of the water in the tub.
2.3: Spin value
2.4: Spin speed icons.
• No spin
• Rinse Hold
• Night Cycle
During the spinning phase the spiral is ani-
mated.
No spin option eliminates all the spin phases
and increases the number of rinses for some
programmes.
Rinse Hold: by selecting this option the wa-
ter of the last rinse is not emptied out to pre-
vent the fabrics from creasing. When the pro-
gramme has finished the display shows
flashing
, the icon 2.8 is still visualized,
the light of button 8 is off and the door is
locked to indicate that the water must be
emptied out. To empty out the water, please
read the paragraph «At the end of the pro-
gramme».
Night Cycle: by selecting this option, the
machine will not drain the water of the last
rinse, so as not to wrinkle the laundry. As all
spinning phases are suppressed, this wash-
ing cycle is very noiseless and it can be se-
lected at night or in times with a more eco-
nomical power rate. On some programmes
the rinses will be performed with more water.
When the programme has finished, the dis-
play shows flashing
still visualized, the light of button 8 is off and
the door is locked to indicate that the water
must be emptied out. To empty out the wa-
ter, please read the paragraph «At the end of
the programme».
2.1 2.2 2.3 2.4 2.5
, Cold .
, the icon 2.8 is
2.12 2.11 2.10
2.6 2.7 2.8 2.9
2.5: Option icons : Extra Rinse
Iron .
2.6: Delay icon
The selected delay set by pressing the rele-
vant button appears on the display for a few
seconds, then the duration of the previously
selected programme is displayed. The rele-
vant icon is lighted on. The delay time value
decreases by one unit every hour and then,
when 1 hour remains, the time decreases
every minute.
2.7: Child safety lock
sation» chapter).
2.8: Door locked icon
After you have pressed button 8 and the ma-
chine has started, this icon is lighted on and
only the phase running icon stays on. When
the programme has finished, three flashing
zeros ( ) are displayed and this icon
disappears.
2.9:
• Duration of the selected programme
After selecting a programme, the duration
is displayed in hours and minutes (for ex-
ample ). The duration is calculated
automatically on the basis of the maximum
recommended load for each type of fabric.
After the programme has started, the time
remaining is updated every minute.
• End of programme
When the programme has finished three
flashing zeros (
icon 2.8 disappears and the door can be
opened.
• Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message Err is displayed at the bottom of
the display for a few seconds and the in-
tegrated red light of button 8 start flashing.
• Alarm codes
or Easy
(see «Personali-
) are displayed, the