Electrolux JRU 44601 Operating Instructions Manual page 24

1xB
1xA
1
1. Installation kit
2. Two cabinet securing brackets (D) are supplied
with the installation pack. They need to be
assembled onto the cabinet prior to cabinet being
pushed into the Kitchen aperture.
Left hand
bracket
2
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
3. Push the appliance into place. The plug socket
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
24
2xC
1xK
18xI
Right hand
bracket
4. The joint cover (B) is to be assembled after having
+
-
-
+
max. 890 mm
3
To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw
in the front kick plate to the left or right.
1
4
installed the appliance in the recess.