System Memory; Auxiliary Source Selection - Emerson Research ES1 Owner's Manual

6. To enhance the bass response, especially at lower volume levels, press the X-BASS button on
the top panel. The X-BASS indicator appears in the display to confirm that the X-BASS circuit is
'On'.
Note: If you are listening to loud rock music with heavy bass, the EQ set to 'ROCK', and the X-BASS
circuit 'On', you might experience some distortion from the speakers. If this occurs, lower the
volume or switch the X-BASS circuit 'Off'.
7. When you are finished listening, press the Power button to turn the system 'Off'. The main
display changes from radio frequency to time, the display lighting goes 'Off' and the standby
indicator comes 'On' again.
Presetting Your Favorite Stations
This system allows you to preset up to 20 of your favorite stations (any combination of FM and AM)
in the tuner memory for easy, one-touch recall at any time. The instructions for presetting stations
will be found in the Remote Control Operation section later in this manual.

SYSTEM MEMORY

The system memory remembers all of the settings you selected before the power was switched
'Off', and automatically returns to those settings (Function, Band, Station, Volume, EQ, and
X-BASS) when the system is switched 'On' again. Note: If the system is unplugged or the AC power
is interrupted, the system memory will be erased.

AUXILIARY SOURCE SELECTION

To listen to an auxiliary source which is connected to the Auxiliary Input jacks on the back panel of
this unit:
1. Press the Tape/Aux button on the top panel. The standby indicator goes 'Off', the main display
comes 'On', and AUX appears in the display.
2. Operate your auxiliary device according to its own instructions.
3. Adjust the Volume, Preset EQ, and X-BASS controls on this system to your desired settings.
4. When you are finished listening press the Power button to shut the system 'Off'. Also shut off the
power on the auxiliary device as well.
To record from the tuner or CD player in this system to an external recording device which is connected
to the Auxiliary Output jacks on the back panel of this unit, operate the tuner or CD player of this unit
as you would normally. Operate your external recording device according to its own instructions. If
your external recording device has recording volume level controls and recording level meters, be
sure to adjust them properly to prevent saturation and distorted recordings.
13