Advertisement
Quick Links
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Important: Read entire instruction sheet before
assembling or installing mantel kit.
These mantels are only approved for use with any
DESA Heating, LLC 26" electric and gas fireplace sys-
tems. Do not use mantel with any other product.
This mantel kit contains the following:
• Mantel pieces - unassembled and numbered as follows:
#1 Base
#2 Right Side Assembly
#3 Left Side Assembly
#4 Header
#5 Top
#6 Top Triangle
#7 Top Left Support
#8 Top Right Support
#9 Top Center Support
#10 Base Support
#11 Vertical Support
Right Top Trim Strip
Left Top Trim Strip
• Hardware Package
22 - 1
/
" Wood Screws
1
4
8 - 1" Finishing Nails
4 - 2" Wood Screws
* Extra hardware may be included
Tools required:
• Power Screwdriver with #2 Phillips Bit
• Hammer
• Nail Set
C26TU and C26TO
Corner Mantel and Base
114325-01
114295-04
122447-01
www.desatech.com
If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement. If
hardware is missing or damaged, contact DESA Heating, LLC
at 1-866-672-6040 for referral information. You can also visit
DESA Heating, LLC's web site at www.desatech.com.
WARNING: Follow guidelines of paint or finish
manufacturer. Use care when finishing or painting an
unfinished mantel (C26TU only). Do not finish or paint
mantel pieces near running heater or open flame. These
vapors are highly flammable.
IMPORTANT: If you are staining an unfinished mantel (C26TU
only), remove any sawdust, dirt or oils. This will prevent blem-
ishes from appearing under the stain. Stain mantel before
assembling according to manufacturer's instructions. Apply
sanding sealer.
IMPORTANT: If you are painting an unfinished mantel (C26TU
only), assemble mantel before painting. Follow directions
listed on paint for wood products. Apply base coat and top
coat following directions listed on product.
Note: Gather all mantel pieces together before assembling
mantel.
WARNING: Only use 1
mantel. Damage to mantel will result if other screws
are used for this purpose.
/
" screws to assemble
1
4
Advertisement
Related Manuals for Desa C26TO
Summary of Contents for Desa C26TO
-
Page 1: Assembly And Installation Instructions
C26TU and C26TO Corner Mantel and Base ASSEMBLY AND INSTALLATION INSTRUCTIONS Important: Read entire instruction sheet before If any wood pieces are missing or damaged, contact the assembling or installing mantel kit. dealer where you purchased this mantel for replacement. If hardware is missing or damaged, contact DESA Heating, LLC These mantels are only approved for use with any at 1-866-672-6040 for referral information. -
Page 2: Assembling Mantel
ASSEmbLING mANTEL Right Leg Important: more than one person is required to lift Assembly assembled mantel. Lift mantel by leg assemblies. Lifting " by header or mantel top could damage mantel. Screws Use the following illustrations to assemble mantel. Use only Left Leg screws provided. -
Page 3: Fireplace Installation
Fireplace Installation 1. Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual. Mantel Top Assembly 2. Mantel must be installed flush with two walls. Remove baseboard along walls where mantel is to be installed. Baseboard will prevent proper installation of mantel and base. -
Page 4: Mantel Installation
Electric Fireplace Installation mANTEL INSTALLATION 1. Carefully push mantel and base into position in corner This mantel can be used with DESA Heating, LLC electric and flush against both walls. Check operation of fireplace fireplaces. Electric fireplaces install from the front of mantel. before proceeding.