Sony STR-K700 - Fm Stereo/fm-am Receiver Service Manual page 2

STR-K700
General
Power requirements
120 V AC, 60 Hz
Power consumption
Area code Power consumption
US 210 W
Canadian 290 VA
Power consumption (during standby mode)
0.2 W
Dimensions (w/h/d) (Approx.)
17 × 5 6/8 × 12 1/8 inches
including projecting parts
and controls
Mass (Approx.) 16 lb 9 oz
Design and specifications are subject to
change without notice.
2
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
About area codes
The area code of the receiver you purchased is
shown on the lower right portion of the rear panel
(see the illustration below).
R L
+ +
R L
CENTER FRONT
Any differences in operation, according to the area
code, are clearly indicated in the text, for example,
"Models of area code AA only".
MODEL IDENTIFICATION
– Rear Panel –
Parts No.
Model
US model
Canadian model
Area code
Part No.
2-661-458-0[]
2-661-458-1[]