Moving The Server's Ip Address To The Top Of The Ip Settings List; Stopping Applications Using The Server's Ip Port - Smart Technologies SMART Bridgit 4.5 Installation And System Administrator's Manual

A P P E N D I X A
Troubleshooting
I
I M P O R T A N T
Because other applications can use the hostname, you should remove the line you added in step 4
after you configure the SMART Bridgit Server. You can remove the line or comment it out (by
inserting a "#" character at the beginning of the line).

Moving the server's IP address to the top of the IP settings list

g
To move the server's IP address to the top of the IP settings list
1. If you don't know the IP address that was entered when the server was installed, open SMART
Bridgit Administration Tools, and then select the Setup tab.
Note the server's IP address in the IPv4 Address drop-down list.
2. Select Start > Control Panel> Network Connections.
3. Right-click the network device that SMART Bridgit software is bound to, and then select
Properties.
4. Click Internet Protocol (TCP/IP) in the This connection uses the following items list.
5. Click Properties.
6. Select the General tab, and then click Advanced.
The Advanced TCP/IP Settings dialog box appears.
7. Click the IP Settings tab.
8. Remove all the IP addresses above the SMART Bridgit server's address.
9. Replace the addresses below the server's address.
10. Restart the server.

Stopping applications using the server's IP port

T
T I P
Perform this procedure when it won't affect other users.
74