%
READ AND UNDERSTANDTHESEINSTRUCTIONS BEFOREINSTALLINGFIXILfRE
INSTRUCTION SHEET NO.
tisfixiure is intended for installation in accordance withthe Nefional E lectrical C odeandlocalregulations.
Jassurefull complianm with local codes and regulations, check with your Iocd electrical inapecfor before
stallation. To prevent elestrfcal shock, turn oft elecfriufy at fuse box before proceeding.
IS:40714
Retain these inatructiona for maintenance reference.
1292
Page 1 of 2
INSTRUCTIONS
FOR
INSTALLATION
OF TRADITIONAL
STYLE
RADIANCE
PENDANTS
'[XTUREASSEMBLY AND INSTALLATION:
1. Carefully remove CENTER STEM ASSEMBLY f rompackaging.
2. Unscrew KNURLED
RING from CANOPY LOOP and allow KNURLEO RING and CANOPY to slide down CHAIN to expose CROSSBAR.
3. Mount CROSSBAR and CENTER STEM ASSEMBLY/CHAIN to OUTLET BOX using OUTLET BOX SCREWS (provided with outlet box).
4, Make electrica ccfnnections black ftiure lead or fixture lead without tracer marks to (hot) black supply lea~ white fixhrra lead or fixture lead with trecer mark
to (neutral) white supply lead. Uninsulated wire is a ground and must be attached to GREEN GROUNO SCREW enclosed in CUPPEO WASHER and tightened
in place to ctossbar, then sunnected to grounding terminal or ground lead inside OUTLET BOX. Use WIRENUTS (local hardware item).
CAUTION
Push supply wires and wirenut connections back into OUTLkT BOX.
5. Adjust NIPPLE into CROSSBAR to proper CANOPY depth and secure NIPPLE in place by tightening LOCKNUT against CROSSBAR.
B, Slide CANOPY up CHAIN and secare against ceiling by thraadng KNURLED RING onto CANOPY LOOP.
7. Loosen
and remove three BATTERY NUTS and STAR WASHERS from MOUNTING STUDS on LOWER FIXFURE ASSEMBLY.
8. Raise LOWER FIXTURE ASSEMBLY to MOUNTING
PLATE on CENTER STEM ASSEMBLY and make
electrical connections
Snap together BLACK
9,
FIG. 1
1.1<>
9-I TC>LI
E la" RRiR511wM:E