Enable Dynamic Routing On Your Router - TRENDnet TEW-716BRG User Manual

TRENDnet User's Guide
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see
on page 18).
2. Click on Configuration at the top of the page, click on Advanced Setting, and click on
Routing.
3. Next to Static Routing, check the Enable option to enable static routing.
4. Review the static route settings.
• Destination – Enter the IP network address of the destination network for the
route.
(e.g. 192.168.20.0)
• Subnet Mask – Enter the subnet mask of the destination network for the route.
(e.g. 255.255.255.0)
• Gateway – Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
• Hop – Enter the number of hops (routers) required to reach the destination
network. The hop count range that can be specified is 0-99.
• Enable – Check the option to enable the route and uncheck the option to disable
the route.
5. To save changes, click Save at the bottom of the page.
Note: If you would like to discard the changes, click Undo before you click Save.
© Copyright 2012 TRENDnet. All Rights Reserved.
"Access your router management page"

Enable dynamic routing on your router

Advanced Setting > Routing
You may want set up your router to route computers or devices on your network to
other local networks through other routers. If other routers support dynamic routing
such as RIP (Routing Information Protocol), you can enable this feature on your router
to automatically learn the required routes to reach those networks. It is required that
the same dynamic routing protocol and version is also enabled on the other routers in
order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see
on page 18).
2. Click on Configuration at the top of the page, click on Advanced Setting, and click on
Routing.
3. Select the appropriate dynamic routing protocol and version communicate with other
routers.
• Disabled – Disable sending and receiving or exchange of routing information
dynamically between your router and other routers.
• RIPv1 - Enables sending and receiving or exchange of routing information
dynamically between your router and other routers to build routes to your network
and other networks using the RIP version 1 protocol.
• RIPv2 – Enables sending and receiving routing information dynamically between
your router and other routers to build routes to your network and other networks
using the RIP version 2 protocol.
4. To save changes, click Save at the bottom of the page.
Note: If you would like to discard the changes, click Undo before you click Save.
TEW-716BRG
"Access your router management page"
35