Ryobi YN250FSD Operator's Manual page 13

LOADING THE TOOL WITH NAILS
See Figures 6 - 7.
 Connect the tool to the air supply.
WARNING:
The tool's driving mechanism may cycle when the tool
is first connected to the air supply. Always connect the
tool to the air supply before loading nails to prevent
injury from unintended cycling. Always make sure the
tool's magazine is empty at the beginning of each work
session, before connecting to an air supply.
WARNING:
Keep the tool pointed away from yourself and others
when loading nails. Failure to do so could result in
possible serious personal injury.
WARNING:
Use only the nails recommended for use with this tool.
The use of any other nails can result in tool malfunction,
leading to serious injuries.
WARNING:
Never load nails with the workpiece contact or trigger
activated. Doing so could result in possible serious
personal injury
 Slide the pusher all the way to the rear of the magazine
until it locks into place.
 With the nose of the tool pointed away from you, feed
a strip of nails into the magazine. Be sure the nails are
pointed downward as shown.
 Depress the pusher release located on the top of the
magazine to allow the pusher to move the nails up to the
driving mechanism. The pusher will stop when it rests
against the end of the nail strip.
.
OPERATION
pUsHer
13
Nails
pUsHer
release
pUsHer
pUsHer
release
Fig. 6
Fig. 7