Connect Water Supply; Connect Drain Line; Drain Line Installation - GE CDWT9 - Cafe 24 in. Dishwasher Installation Instructions Manual

Dishwasher Installation
STEP 17 - CONNECT WATER SUPPLY
Connect water supply line to the 90 ° elbow.
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90 ° elbow.
• Slide ferrule against elbow and secure with compression nut.
IMPORTANT-
Check to be sure that door spring does
not rub or contact the fill hose or water supply line. Test bg
opening and closing the door. Reroute the lines ifa rubbing
noise or interference occurs.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
the previously determined method.
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Figure EE _o
STEP 18 - CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fit
the inlet port.
..................... -- Method 1 - Air gap with waste tee or disposer
Compression Nut Insert the drain hose into the air gap as shown.
Ferrule
Hot Water _/ _
_0° E!b°wsupply Line
II
_oo Elbow WguSrteeTHee Installation Disposer Installation
\ Door Spring
Method 2 - High Drain Loop with the Waste Tee or Disposer
Route the drain hose of the dishwasher to (] minimum height of 32" from
the floor with the supplied hanger as shown.
Cutting Line IMPORTANT: Do not cut corrugate(
_!_ _ portion of hose
r n __/8'-]',
Figure FF
• If u longer drain hose is required, and you did not purchase
10' long GPFIOL drain hose, odd up to 3-1/2' of length for o
total of 10' to the factory-installed hose. Use 5/8" or
Coupler
!a_ste Tee instaJal
7/8" inside diameter
hose and u coupler
to connect the
two hose ends.
Secure the
connection with
hose clumps.
Hose Clump
Figure GG
'1--_. _ i J'_ t __
32" ,,
on Disposer Installation
Figure II
IM PORTANT-
One of the above methods must be
used or dishwasher will not operate properly.
IM PORTANT-
When connecting
drain line to disposer, check to be sure __
that drain plug has been removed.
k:#
DISHWASHERWILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
Hose Clump Tip: Avoid unnecessary service coil charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
Remove
Hopper
Plug
13