Lightolier ELLIPSOIDAL DOWNLIGHT Instructions For Maintenance Reference

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTALLATION PROCEDURE FOR ELLIPSOIDAL DOWNLIGHT (A-LAMP)
CAUTION: (RISK OF FIRE)
A. INSTALL MOUNTING FRAME IN CEILING USING ADJUSTABLE
MOUNTING BRACKET
(1) With MOUNTING BARS (order separately):
18" – Cat. No. 1950; 27" – Cat. No 1951).
Use rectangular slots as shown.
FIG. 2
Slide MOUNTING BARS or CHANNELS (by others) through slots in ADJUSTABLE MOUNTING BRACKET which will place the
bottom of the MOUNTING FRAME approximately in line with the finished ceiling line. Final adjustments may be made by means of
MOUNTING BRACKET SCREWS on inside of fixture.
For wood joist construction:
MOUNTING BARS No. 7994 (order separately) may be
used to secure MOUNTING FRAME (Fig.5).
FIG. 5
DO NOT INSTALL INSULATION ABOVE, NOR WITHIN 3 INCHES (76mm) OF ANY PART OF
THE LUMINAIRE.
FIG. 1
(2) With ¾" channel (by others)
TELESCOPING
TELESCOPING
MOUNTING BARS
FIG. 3
For suspended ceilings:
ACCESSORY No. 1956 (order separately) may be used
with 18" or 27" MOUNTING BARS or TELESCOPING
MOUNTING BARS for quick mounting (Fig. 6) or simply
wire MOUNTING BARS to ceiling members (Fig. 7)
T-BAR ANCHOR
MOUNTING
BAR
ACCESSORY
FIG. 6
631 Airport Road, Fall River, MA 02720
INSTRUCTION SHEET NO.
IS:7784
A0302
(3) With 1 ½" channel (by others)
FIG. 4
T-Bar ANCHOR CLIPS
WIRE
CLIPS
MOUNTING
BAR
FIG. 7
A
Page 1 of 3
COMPANY