r
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
Thisfixtureis intendedforinstallation inaccordance withthe National
Electrical Code and load regulations.
To assure full compliance withlocalcodesandregulations, c heckwithyourlocalelectrical i nspector
before
installation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding.
Retain these instructions
for maintenance reference.
INSTRUCTION SHEET NO.
IS:6079
0493
Page 1
of 2
INSTALLATION FOR AITACHING EXTENSION WAND SLOPED CEILINGS ADAPTER
TO LYTESPAN TRACK. FOR USE WITH LYTESPAN" TRACK SYSTEMS ONLY
Extensionwandslopedceilingadaptercan be mountedon any Basic,Advent Multipointor MonopointTrackon tailings
from 0° to 90° (vertical).
Notfor usewith Lytespota with attachment f itting 7589.
1.
Grasp TOP FITTING at top of ADAPTER and insert it into the LYTESPAN TRACK. The LOCKING LEVER must be on the same side of the track as the BEAD.
(see Fig. 1.)
2. Rotate the TOP FI'ITING W' clockwise, (See Fig. 2), until LOCKING LEVER snaps and locks in plats. (See Fig. 3.) Do not rotate adapter from LOWER FllllNG.
3. Loosen KNOB and set the lower haff of the ADAPTER to a vertical positionand tighten KNOB. (Fig, 4)
4. To Remove Depress LOCKING LEVER; then rotate TOP FllllNG 90° counter-dockwke. Do not rotate wand from LOWER FITTING,
BEAD
LOCKING
LEVER
FIG. 1
LVTESPAN
TRACK
FITTING
c
-u
CLOCKWISE
FIG.
2
!l-
ri
FIG. 3
NG
L
'"WERF'"'N
I
I
I
FIG. 4
INSTRUCTIONS
FOR CONVERTING FITTING TO OPERATE ON
2 CIRCUIT TRACK SYSTEMS
BRASS CONTACT
See Fig. 5, BRASS CONTACT can be raisedor lowered,Brokenline indicatesposition for 1 circuit
track or lower circuitof 2 circuittrack system.
L::;;:G
To mnverf attachment FllTING for upper circuitof 2 circJJit track, raise BRASS CONTACT to high
position by Ming CONTACT as high as stop f.wrnits and CONTACT clicks into place.
FIG. 5
INSTRUCTIONS
FOR AllACHING
EXTENSION WAND TO EXTENSION WAND SLOPED CEILING ADAPTER
1.
Insert the WAND FllllNG
into the LOWER FllllNG.
The LOCKING LEVER must be on the same side as the bead located at the bottom of the LOWER FllTING (See Fig. 6.) Rotate the WAND FllllNG
90° clockwise until LOCKING LEVER snaps and locks in place. (See Fig. 6,7, & 8).
2, To remove, depress LOCKING LEVER and rotate FllllNG
90° counterclockwise.
$
/-
R/la
BEAD
BRASSCONTACT
"OWN
LOCKING_
_
WAND
CLOCKWISE
LEVER
FllTNG
1
FIG. 6
FIG. 7
i
FIG. 8