Television Safety - Hitachi C55WP910TN User Manual

satellite and VCR installation
connect aerial
1
connection lead to
the analogue'in' socket
marked
2
connect Satellite 'out' to VCR
socket 'in' marked
connect VCR 'out' to analogue
3
TV socket 'in' marked
A scart lead should be fitted between your TV and VCR to enhance your picture and sound quality.
Scart leads are essential if you have a stereo TV and VCR and wish to obtain stereo sound from your
equipment. These leads can also be purchased from your Hitachi dealer or any good electrical retailer.
VHS video equipment should be connected to the AV2 scart socket located at the rear of your TV. A
dedicated program number may be assigned to AV2, allowing you easier access to view external equipment
broadcasts. How to assign an AV signal to dedicated program numbers is explained in Signal Source Entry.
To avoid picture interference it is recommended that connection cables are kept from the right hand
Before you switch on your television, it is important that the external speakers supplied
with your television are connected. This can be seen in the section other equipment
connecting to the mains socket
Please Note: - If you have not already done so, please read television safety
insert plug...
8
receiving aerial
aerial wall socket
connection - rear socket and scart details
before connecting your television and external equipment.
side of the rear of the TV.
scart lead
Satellite
Decoder
(this should be
plugged
into a mains
socket)
Video
Cassette
Recorder
(this should be plugged
into a mains socket)
...and switch on