Size Switching; Input Signal Screen Display - Hitachi 42PD4200 User Manual

Size Switching

Each time the ZOOM button of the remote control is pressed, the screen display area will change in sequence and the
status will be displayed at the bottom of the screen.
* Real mode gives the image of the same shape as it is displayed on a computer monitor.
This mode is only available for VGA (640 X 480) and WVGA (864 X 480).
Display area selection diagram (RGB input)
Resolution Full display
Display
640 X 480
(VGA)
800 X 600
(SVGA)
1024 X 768
(XGA)
1280 X 1024
(SXGA)
1600 X 1200
(UXGA)
Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that
flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On
the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.
• The display will go out in approximately 6 seconds.
16
Full Normal
RGB
Off-timer
-- -- Min.
OFF
On-timer
-- -- : -- --
Normal Full Zoom1
*
Real Zoom3 Zoom2
Circular display
Real
* VGA and W-VGA
only
RGB2
RGB
H : 48.4kHz
V : 60.1 Hz
D / N
i +
I / II
A / B 2-4-12
MENU
P+
- +
OK
P-
D V D
FREEZE
ZOOM
Zoom1 Zoom2
Input mode
Signal mode
Input horizontal frequency
Input vertical frequency
RECALL button
ZOOM button
Zoom3
can reduce
21