Table of Contents
Advertisement
Programming of the LCD Transmitter
Button
SET
SET
SET
SET (3X)
SET & LOCK
SET & UNLOCK
SET &
SET &
Programming the LCD Transmitter
Screen Lamp On:
Press and hold the "SET" button one second, with the melody sound and the LCD screen lamp
will turn on for 5 seconds.
Power Save Mode:
While in the Power Save Mode, the LCD transmitter uses "0" current to save the battery power.
1. Press and hold the "SET" button for 5 seconds. One melody will sound from the transmitter
and the LCD will show "SAVE". You are now in the "Power Save Mode".
2. Under the Active Arming Mode and Disarm Mode. Turn the ignition switch to the "ON" position.
The LCD remote transmitter will automatically enter the "Power Save Mode"
Exit Power Save Mode:
Press any button on the LCD transmitter to exit the Power Save Mode.
Clear the Flash Icon and Melody Sound:
Press the SET button 3 times within 3 seconds and it will clear the flashing icon and melody
sound on the LCD transmitter.
Stop the Trigger Melody:
While triggering the alarm, the LCD screen will alert the user through melody sound and flashing
trigger icon. Press any button on the transmitter to stop melody sound only.
Button Lock:
Use this mode to disable the transmission function of the remote control temporarily to prevent
any inadvertent pressing of buttons.
1. Press the "SET" button first, within 3 seconds press and hold the
activate or cancel the button lock function. The
show button lock mode.
16
Description
LCD Screen Lamp Turns ON for
Five Seconds
Timer Programming Mode
Power Save Mode
Clear the Flash Icon and Melody Sound
on the LCD Screen
Button Lock Enabled/Disabled
Melody/Vibrate Mode
Program Count Down Timer
(10 m, 20 m, 30 m, 1 hr, 1.5 hr, 2 hr)
Enable/Disable Beep Sound while
Pressing Button
Operation
Press and Hold for 1 Second
1 Melody Sounds to Confirm
Press and Hold for 3 Seconds
2-Melody Sounds to Confirm
Press and Hold for 5 seconds
1 Melody Sounds to Confirm
Press within 3 Seconds
Press within 3 Seconds
Press within 3 Seconds
Press within 3 Second Cycles
Leave the Buttons Starting Count
Down then Timer Icon Flashes
Press for 2 Seconds
icon will be displayed on the LCD screen to
button for 2 seconds to
Advertisement
Table of Contents
