7
6
80
Correction
Height of the thread catcher
–
Loosen screw 2.
–
Adjust the height of block 3.
–
Tighten screw 2.
Distance between thread catcher and needle
–
Loosen counter-nut 1.
–
Set the distance to the needle with the stop screw 7.
The distance between thread catcher and needle must amount to
approx. 7 - 8 mm. In some cases the distance to the needle can
slightly differ from this value.
–
Tighten counter-nut 1.
Lower position of the thread catcher
–
Set the lower position of the thread catcher with the knurled
screw 4.
The distance between thread catcher and fabric must amount to
approx. 3 mm.
–
Press the thread catcher down manually and check the position of
the thread catcher.
Lateral position of the thread catcher
–
Loosen screws 6.
–
Adjust the lateral distance of the thread catcher 5.
–
Tighten screws 6.
1
2
3
4
5