Lenovo ThinkStation D20 Hardware Maintenance Manual page 69

Diagnostic Error Code
014-197-XXX Parallel port test warning
014-198-XXX Parallel port test aborted
014-199-XXX Parallel port test failed, cause unknown
014-2XX-XXX 014-3XX-XXX Parallel port failure
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
FRU/Action
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See "Flash update
procedures" on page 251
3. Go to "Undetermined problems" on page 75
1. Go to "Undetermined problems" on page 75
2. Flash the system and re-test. See "Flash update
procedures" on page 251
3. Replace component under function test
1. External parallel device
2. System board
No action
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Flash the system. See "Flash update procedures"
on page 251
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Flash update
procedures" on page 251
3. Run memory test
4. System board
1. Remove USB device(s) and re-test
2. System board
System board
1. Run setup and check for conflicts
2. Flash the system. See "Flash update procedures"
on page 251
3. System board
Information only Re-start the test, if necessary
Chapter 9
.
Symptom-to-FRU Index
61