Replacing The Optical Drive - Lenovo ThinkStation C30 User Manual

Machine types: 1095, 1096, and 1097
Hide thumbs Also See for ThinkStation C30:
Table of Contents

Advertisement

7. Position the new memory module over the memory slot. Make sure that the notch
module aligns correctly with the slot key
down into the slot until the retaining clips close.
Figure 18. Installing a memory module
8. Reinstall the PCI Express x16 graphics card if you have removed it. See "Installing or replacing a
PCI card" on page 33.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 57.

Replacing the optical drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the optical drive.
To replace the optical drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 30.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 31.
4. Remove the PCI card holder. See "Removing and reinstalling the PCI card holder" on page 32.
2
on the system board. Push the memory module straight
Chapter 5
1
on the memory
.
Installing or replacing hardware
37

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents