Lenovo ThinkCentre M92z Hardware Maintenance Manual page 91

To install or replace a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the frame stand. See "Removing and reinstalling the frame stand" on page 82.
4. Remove the computer cover. See "Removing the computer cover" on page 83.
5. Locate the memory modules. See "Locating major FRUs and CRUs (for models with the 20-inch display)"
on page 73 or "Locating major FRUs and CRUs (for models with the 23-inch display)" on page 76.
6. Open the retaining clips. If you are replacing an old memory module, open the retaining clips and
remove the memory module being replaced as shown.
Figure 13. Removing the memory module
7. Insert the notched end
firmly and pivot the memory module until it snaps into place. Make sure that the memory module is
secured in the slot and does not move easily.
Figure 14. Installing a memory module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 127.
2 of the new memory module into the slot 1 . Press the memory module
.
Chapter 9 Replacing FRUs
87