Installing Or Replacing A Memory Module - Lenovo ThinkCentre M76 Hardware Maintenance Manual

7. Pivot the card latch to the closed position to secure the PCI card.
Figure 10. Installing a PCI card
8. To complete the installation or replacement, go to "Completing the parts replacement" on page 110.

Installing or replacing a memory module

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace a memory module.
Your computer has four slots for installing or replacing DDR3 DIMMs that provide up to a maximum of 16 GB
system memory. When installing or replacing a memory module, use 1 GB, 2 GB, or 4 GB DDR3 DIMMs
in any combination up to a maximum of 16 GB.
To install or replace a memory module, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 78.
3. Lay the computer on its side for easier access to the system board.
4. Locate the memory slots. See "Locating parts on the system board" on page 76.
5. Remove any parts that might prevent your access to the memory slots. Depending on your computer
model, you might need to remove the PCI Express x16 graphics card for easier access to the memory
slots. See "Installing or replacing a PCI card" on page 80.
6. Depending on whether you are installing or replacing a memory module, do one of the following:
.
Chapter 8 Replacing FRUs (Machine Types: 3114, 3121, 3123, and 3127.)
83