Pulling Up The Bobbin Thread - Brother NV10 Operation Manual

SEWING BASICS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Pulling up the bobbin thread

When making gathers, first pull up the bobbin thread as described below.
a Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
• Leave the bobbin cover removed.
b Lightly hold the end of the upper thread.
a Upper thread
c With the needle raised, press
position button) twice.
a Needle position button
d Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
b
a Upper thread
b Bobbin thread
50
e
a
f
(needle
a
Pull out about 10 to 15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
a
b
a Upper thread
b Bobbin thread
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then press down on the
right side (B).
A A
B