Table of Contents
Advertisement
• The washing machine has stopped with water in
tub, at the end of a programme with NIGHT
CYCLE option: this is indicated by a static zero.
• The washing machine has completed the
programme: this is indicated by a blinking zero.
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
SKIP RESET button.
Important!
The first time you use the washing machine,
when you switch it on, it may display a blinking zero.
This is due to the fact that the washing machine has
performed a washing cycle during the manufacturer's
inspection tests, and this cycle has not been erased
after its completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of every programme by up
to 24 hours in one hour intervals selecting the
DELAY START button.
• An incorrect option selection has been made:
this is indicated by the message Err when a
function incompatible with the current programme
is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 23).
9 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of the
relevant button, the countdown will begin and will
be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
•
Draining of water and spinning after the
completion of programmes with the NIGHT CYCLE
option.
10
Hide quick links:
Advertisement
Table of Contents
