Sansui HDLCD3700C Owner's Manual page 16

Connections to other equipment
To connect an audio system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the
TV's remote control.
To control the audio, turn on the TV and the stereo amplifier, and turn off the TV's built-in speakers (see "Turning
off the built-in speakers" on page 26).
Left side of the TV
NOTE:
To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set
above 0 (zero).
For example, if the volume of the TV is set to 0, you will not be able to hear any sound, even if the volume of the
amplifier is at its highest level.
To connect the LCD TV to a PC (Personal Computer)
Before you connect this LCD TV to your PC, change the adjustment of your PC's Resolution and Refresh rate
(60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA
connector PC MONITOR on the back of the LCD TV. Attach the connectors firmly with the screws on the plug. In
case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to
the AUDIO connector of the PC/HDMI-1 AUDIO IN jack of the LCD TV.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The LCD TV can operate as the computer monitor.
Left side of the LCD TV
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
16
To PC MONITOR IN
To PC/
HDMI-1
AUDIO
IN jack
VGA cable (not supplied)
Audio cord (not supplied)
Amplifier
To Audio (L) Input
Audio cord (not supplied)
Monitor Display modes
MODE
VGA
VGA
SVGA
XGA
WXGA
WXGA
WXGA
To return to normal mode
Press INPUT SELECT again.
To Audio (R) Input
Resolution Refresh rate
640x480 60Hz
720x400 70Hz
800x600 60Hz
1024x768 60Hz
1280x768 60Hz
1280x720 60Hz
1360x768 60Hz