Table of Contents
Advertisement
Problem
No water flows.
E10
Fault code
ap-
pears. The display
RINSE + flashes
The washing machine
vibrates during opera-
tion or is unstable.
Excessive foaming dur-
ing the main wash.
Possible Cause
Water tap is closed.
Filter in screw connection of
the inlet hose is blocked.
Water tap is blocked with
limescale or is faulty.
The transport packaging has
not been removed.
The machine is not level.
There is very little washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped out before
spinning because the drain-
age hose is kinked or the
drain pump is blocked.
Probably too much detergent
was used.
Operating Instructions
Remedy
Open the water tap.
Close the water tap. Unscrew
the hose from the tap, re-
move the filter and clean un-
der running water
Check the water tap and
have it repaired if necessary.
Remove transport packaging
according to the installation
and connection instructions.
Adjust the feet according to
the installation and connec-
tion instructions.
This does not impair the op-
eration of the machine.
Check the the drain hose and
remove any kink if necessary,
or clean the drain pump and,
if required, remove foreign
bodies from the pump hous-
ing.
It may be necessary to re-
duce the amount of deter-
gent used. Follow the
detergent manufacturer's
recommendations.
33
Hide quick links:
Advertisement
Table of Contents
