Precor 954i Owner's Manual page 92

Attach the power cord clips (G).
Important: Use the power cord clips to secure the power cord to the
base frame beneath the hood. This reduces the possibility that the power
cord will get pinched or damaged by the incline lift movement. Keep in
mind users safety and the placement of the power cord. If the power
cord runs along the length of the treadmill use the power cord clips to
secure it to the side rail.
1. Wrap the clip around the power cord near
the power switch at the front of the treadmill
and clamp it shut.
2. Insert the serrated portion of the
clip into the hole located under
the front of the unit on either side
of the power switch.
3. Place the clips, as needed, along
the length of the power cord
while you redirect it to the power
outlet. The holes, found in the
frame beneath the side rail, are
spaced 12 inches (31 cm) along
the length of the side rail.
C954i Commercial Treadmill Assembly Guide
Power cord clip
Side rail
Power cord
Level the unit.
Before allowing users on the unit, make sure it is level.
Important: If the load is not equally compensated, the user will feel
excessive vibration or movement at the display console. Adjust one
rear foot at a time. Do not raise the unit beyond ¾-inch (2 cm).
1. Place a bubble level on the running belt to see if the treadmill is
level. If the treadmill needs leveling, continue to step 2.
2. Situate yourself next to the adjustable rear feet.
3. Ask a capable assistant to lift the rear portion of the treadmill (using
proper lifting techniques).
4. Level the treadmill by adjusting the rear feet as needed.
Important: If the unit is placed on a slightly uneven surface,
rotating the rear feet can help, but will not compensate for
extremely uneven surfaces.
5. Recheck the level of the treadmill with the bubble level on the
running belt after each adjustment.
6. Make adjustments to the rear feet so that the user's weight on the
treadmill is distributed evenly.
Plug the power cord into an appropriate outlet.
Important: The treadmill requires a dedicated, grounded circuit. A
20-amp circuit is recommended. Refer to Grounding Instructions in the
Product Owner's Manual.
Adjustable
rear foot
Bubble
level
6