System Board Connectors - HP Kayak XU800 Technical Notes

Mouse (upper) &
Keyboard (lower)
Two USB
Serial Port A
Serial Port B
(Both ports are stacked
with the Parallel Port)
Midi & Audio
Memory Expansion Card Memory Expansion
Card Connectors- J22 Connectors
One AGP 4x Slot
PCI Slot 1
(32-bit 33 MHz, 5V)
PCI Slot 2
(32-bit 33 MHz, 5V)
Super I/O NS 87364 Chip
CSA4280 Audio PCI chip
PCI Slot 5
(32-bit 33 MHz, 5V)
a. Refer to "System Board Switches" on page 12
board switch settings.
b. Connector for the Anti-Intrusion switch.
c. Optional.
d. Connector for additional control of HDD LED on the status panel through the SCSI controller on a PCI add-on card.

System Board Connectors

The following diagram shows where the different chips and connectors
are located on the E-ATX system board.
c
Fan CPU 1 SCSI Termination
Connector
Processor 1 Connector
Processor 2 Connector
Rear Fan
Line Out
Fan
Line In
c
MIC
CPU2
b
Anti-Intrusion
PCI Slot 4
(64-bit 66 MHz, 3.3V)
PCI Slot 3 (64-bit 66
MHz, 3.3V)
or the Switch Block Label located on the chassis of the system box for the different system
Battery Backup
c
Unit
Memory Controller Hub
(MCH) 8284O-QP
MaxiLife -
Status Panel
Wake-On Lan PCI 64-bit Hub
c
(WOL) (P64H)
Additional SCSI
LED Connector
System Board Connectors
AUX Power
Power Supply
FDD
Secondary IDE
Primary IDE
VRM for socket
CPU 2
HDD Temperature
Sensor
Input/Output Controller
Battery
Hub (ICH) 82801AA
FirmWare Hub
Controller (FWH)
Configuration
82802AB
d
Switches
PCI Fan
CD-ROM Audio In
AUX Audio In
Internal Speaker
Internal SCSI U160
Connector to
Internal Devices
Adaptec 7892 SCSI
U160 Controller
a
English 11