HP Kayak XA-s 02xx Handbook page 9

HP Kayak XA-s DT Series 02xx PC Workstation
Installing a Dual Processor / Replacing a Processor
HP Kayak XA-s PC Workstations are supplied with dual processor slots and
either one or two processors installed. Single processor models can be
upgraded to dual processor systems by installing the second processor
accessory in the vacant slot.
The second processor must be a processor of the same type, speed and level-2
cache memory capacity as the first. It is installed by gently sliding the processor
into the vacant processor connector slot until the two plastic clips at the sides
engage to lock the processor into place.
Every processor that is installed, or replaced, must be accompanied by the
voltage regulator module (VRM) that was supplied with it. Each VRM is specific
to the processor with which it was supplied, and should only be used with that
processor.
NOTE:
Plastic clips
Bracket pillars
7
7-8 HP Kayak XA-s DT Series 02xx PC
Workstation
After installation of a second processor, the operating
system must be reinstalled.
Medium-Profile
Desktop
PC Workstations
Heat-sink