Something Not Working; Fault Codes - Zanussi ZDT 201 User Manual

Hide thumbs Also See for ZDT 201:
Table of Contents

Advertisement

Something not working

The dishwasher will not start or stops during
operation.
Certain problems are due to the lack of simple
maintenance or oversights, which can be
Fault code and malfunction
• continuous flashing of the start/cancel indicator
light
• 1 intermittent audible signal
• 1 flash of the "end of cycle" indicator light
The dishwasher does not fill with water.
• continuous flashing of the start/cancel indicator
light
• 2 intermittent audible signals
• 2 flashes of the "end of cycle" indicator light
The dishwasher will not drain.
• continuous flashing of the start/cancel indicator
light
• 3 intermittent audible signals
• 3 flashes of the "end of cycle" indicator light
The programme does not start.
Once these checks have been carried out;
switch on the dishwasher. The programme will
continue from the point at which it was inter-
rupted.
solved with the help of the indications described
in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the fol-
lowing suggested corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting
at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
• The water inlet hose has not been correctly laid or
it is bent or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or
it is bent or squashed.
Check the water drain hose connection.
• Anti-flood device is activated.
Close the water tap and contact your local Service
Force Centre.
• The dishwasher door has not been properly closed.
Close the door.
• The main plug is not plugged in.
Insert the mains plug.
• The fuse has blown in the household fuse box.
Replace the fuse.
If the malfunction or fault code reappears con-
tact the Service Force Centre.
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents