Replace Auger Belt - Husqvarna OHV Service Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

7.32 Replace Auger Belt

1) Remove spark plug wire from plug.
2) Remove Chute Assy. See section 7.51
3) Remove both 3/8 screws that secure belt
"
cover. Remove belt cover.
RIGHT SCREW
4) Place a chair or saw horse under handle for
support after auger section is split.
RIGHT BOLT
5) Remove both 9/16
powerhead and auger housing together.
6) Remove belt from drive pulley as you
separate the auger from the powerhead
assembly
BELT COVER
LEFT BOLT
hex bolts that hold the
"
www.mymowerparts.com
7) Place new belt on auger pulley.
8) Lift auger housing into position and ensure
that slotted bracket on auger housing are
placed onto the rod at base of powerhead
ROD
9) Route auger belt around pulleys, checking
that the belt does not catch on idler brkt.
10)Reinstall bolts to secure auger housing to
the powerhead.
11)Reinstall the belt cover and the chute
assembly. ( See Section 7.51)
36
SLOTTED
BRACKET
AUGER BELT AUGER BELT
IDLER PULLEY IDLER PULLEY