Installing A Pci Adapter - IBM x3650 - System M2 - 7947 User Manual

4. Press the bracket tab 3 and slide the bracket toward the
5. Return to "Installing a PCI adapter" or "Installing a PCI riser-card assembly" on

Installing a PCI adapter

The following illustration shows the PCI adapter expansion slots from the rear of the
server.
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
v Locate the documentation that comes with the adapter and follow those
v To ensure that a ServeRAID-10i, ServeRAID-10is, or ServeRAID-10M adapter
v Some high performance video adapters are supported by your server. See
v The following notes describe important information about the NVIDIA video
v A PCI Express Gen 2 x16 riser card can support only one adapter.
v A PCI Express Gen 2 x8 riser card and a PCI-X riser card can each support two
v The expansion slots in the PCI riser cards accommodate the various form factors
expansion-slot-opening end of the assembly until the bracket clicks into place.
page 45, as applicable.
instruction in addition to the instructions in this section. If you have to change
switch settings or jumper settings on the adapter, follow the instructions that
come with the adapter.
works correctly in your UEFI-based server, make sure that the adapter firmware
is at the latest level.
Important: Some cluster solutions require specific code levels or coordinated
code updates. If the device is part of a cluster solution, verify that the latest level
of code is supported for the cluster solution before you update the code.
http://www.ibm.com/servers/eserver/serverproven/compat/us/ for more
information.
adapter that comes preinstalled in some server models:
– Do not set the maximum digital video resolution above 1600 x 1200 at 75
MHz for an LCD monitor. This is the highest resolution that is supported for an
optional video adapter in the server.
– Any high-definition video-out connector or stereo connector on an optional
video adapter is not supported.
adapters.
of the non-hot-plug adapters as follows:
– Expansion slot 1: Full-height, full-length
– Expansion slot 2: Low-profile with standard bracket
– Expansion slot 3: Full-height, full-length
– Expansion slot 4: Full-height, half-length
If you install a different supported riser-card assembly, the supported adapter
types might be different. For a list of supported riser-card assemblies, see
http://www.ibm.com/servers/eserver/serverproven/compat/us/.
Chapter 2. Installing optional devices
51