Installing The Blade Server In A Bladecenter Unit - IBM HS21 - BladeCenter - 8853 User Manual

4. Lower the cover so that the slots at the rear slide down onto the pins at the rear
5. Pivot the cover to the closed position, as shown in the illustration, until it clicks

Installing the blade server in a BladeCenter unit

The following illustration shows how to install a blade server into a Type 8677
BladeCenter unit. The appearance of your BladeCenter unit might be different, see
the documentation for your BladeCenter unit for additional information.
Release handles
(open)
To install a blade server in a BladeCenter unit, complete the following steps.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
36
BladeCenter HS21 Type 8853: Installation and User's Guide
of the blade server, as shown in the illustration. Before you close the cover,
make sure that all components are installed and seated correctly and that you
have not left loose tools or parts inside the blade server.
into place.
1. Read the safety information that begins on page v and "Installation guidelines"
on page 15 through "Handling static-sensitive devices" on page 16.
2. If you have not done so already, install any options that you want, such as
SAS drives or memory, in the blade server.
3. (BladeCenter T unit only) Remove the bezel assembly on the BladeCenter T
unit. For detailed instructions for removing the bezel assembly, see the
Installation and User's Guide that comes with the BladeCenter T unit.