Prior To Initial Start-Up - AEG SANTO 3274 Operating Instructions Manual

Applies only to the temperature display for the refri-
gerator
• When the FAST CHILL function is switched on (see also section: "Fast
Chill/Fast Freeze"), "IC" is displayed in the temperature display. As
long as the FAST CHILL function is switched on, no refrigerator tem-
perature is indicated in the temperature display.
Applies only to the temperature display for the free-
zer compartment
• If, for example, frozen goods have been partially or completely tha-
wed due to a power failure, the temperature display alternately indi-
cates:
– the freezer compartment temperature (ACTUAL temperature) and
– the highest temperature to which the frozen goods have warmed.

Prior to Initial Start-Up

Before connecting the appliance to the mains and putting it into ope-
1
ration for the first time, leave the appliance to stand for 30 minutes if
it was transported upright. After transport on its side, the appliance
must be left to stand for 4 hours before putting it into operation. This is
necessary to allow the oil to flow back into the compressor. Otherwise
the compressor may be damaged.
0 Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Maintenance and Cleaning").
0 Remove the cold accumulation block from the freezer tray.
0 Place the cold accumulation block into a compartment or drawer only
after the optimal storage temperature of -18°C has been reached, and
allow to freeze.
0 After 24 hours place the cold accumulation block at the front of the
freezer tray.
0 Re-freeze the thawed cold accumulation block in the same fashion, e.g.
after cleaning the appliance.
20
818 14 00-01/4