Brother FAX560 Service Manual page 116

Selector
No.
1 Detection time length of the
| disconnection tone in ICM
4 recording
5
| Not used.
8
NOTE: Selectors 1 through 4 are applicable to those models equipped with a built-in TAD.
l Selectors 1 through 4: Detection time length of the disconnection tone in ICM recording
If the equipment detects disconnection tone for the time length set by these selectors, it will
disconnect the line.
Selector
No.
1
| Not used.
5
6 Lower limit of frequency to be
| ignored after detection of calling
8 signals (Ci)
Selectors 6 through 8: Lower limit of frequency to be ignored after detection of calling signals (Ci)
l
At the start of reception, if the equipment detects the frequency of calling signals (Ci) specified by
selectors 1 through 4 of WSW14, it will start the ringer sounding. When doing so, the equipment
may fail to detect the calling signals normally due to noises superimposed at the time of reception.
To prevent it, use selectors 6 through 8 of WSW36.
If the equipment detects higher frequencies than the lower limit specified by these selectors, it will
regard them as noise and interpret that detecting state as being normal, allowing the ringer to keep
sounding (until the equipment starts automatic reception of FAX data if in the FAX mode or enters
the TAD mode if set in the TEL mode, according to the preset number of ringers).
WSW35
(Function setting 13)
Function
WSW36
(Function setting 14)
Function
V - 48
Setting and Specifications
No. 1 2 3 4
0 0 0 0 :
0 0 0 1 :
0 0 1 0 :
0 1 0 0 :
I
1 1 1 1 :
Setting and Specifications
No. 6 7 8
0 0 0 : 0 (Not ignored)
0 0 1 : 4 (448 Hz)
0 1 0 : 8 (244 Hz)
0 1 1 : 12 (162 Hz)
1 0 0 : 16 (122 Hz)
1 0 1 : 20 (97 Hz)
1 1 0 : 24 (81 Hz)
1 1 1 : 28 (69 Hz)
No detection
1 sec.
2 sec.
4 sec.
I
15 sec.