Attach The Bottle Holder/Accessory Tray - Precor Experience Strength™ C-Line User Manual

Attach the Bottle Holder/Accessory Tray

To Attach the Bottle Holder/Accessory Tray to the
Weight Tower Frame:
1. Locate the bottle holder and accessory tray. Snap the two pieces
together and set them aside.
Note: The bottle holder/accessory tray attaches to the side of the
back weight tower upright.
2. Place the bottle holder bracket upside down (curved side at the top)
and attach it to the weight stack tower using:
Two custom bolts
Two lock washers
Two flat washers
Two " - 16 low head bolts
One " hex key
One 1" open-ended wrench
Note: The custom bolts pass through the frame from the inside hole
and align with the smaller hole on the outside of the frame.
Figure 6: Attachment of bottle holder bracket
Rear Delt/Pec Fly Assembly and Delivery Guide: Attach the Bottle Holder/Accessory Tray
3. Set the bottle holder/accessory tray on the top of the bottle holder
bracket and align it with the bracket screw holes. Attach it to the
bracket using:
Two #8 - 32 machine screws
Note: Attach the screws firmly, but do not overtighten.
Figure 7: Bottle holder/accessory tray attachment
6