3Com 3C63100-AC-C - PathBuilder S600 Bridge/router Reference Manual page 193

Table 36 PathBuilder S600 Alarm Messages (continued)
Alarm Definition
Wrong slot for card Indicates that a wrong card has been inserted into a slot designated
for other cards.
Bus A Parity Error Bus A Parity Error
Bus B Parity Error Bus B Parity Error
Bus C Parity Error Bus C Parity Error
Bus D Parity Error Bus D Parity Error
Loss 25MHz ATM Clock The ATM 25Mhz clock is lost.
Loss 8KHz Ref Clock Internal 8khz reference clock is lost
Loss BITS Input Signal Bits clock is lost
ALM Ingress FIFO ATM Layer Manager (ALM) Ingress FIFO overflowed
Overflow
ALM Dest Slot Overrun ATM Layer Manager (ALM) destination overrun.
ALM Ingress VPI Over VPI is out of range
255
ALM Ingress VCI Out of VCI is out of range
Range
ALM Ingress Sync Error Ingress synchronization error
ALM Parity Error ATM Layer Manager (ALM) Parity Error on the Egress
Egress/QCX
ALM Parity Error ATM Layer Manager (ALM) Parity Error on the Ingress
Ingress/CB
ALM Ext SRAM Parity Er External ALM SRAM parity error
Queue 0 Over Threshold Queue 0 overflowed
Queue 1 Over Threshold Queue 1 overflowed
Queue 2 Over Threshold Queue 2 overflowed
Queue 3 Over Threshold Queue 3 overflowed
Group Multi Test Different test procedure request from different links in an IMA
group from the Far End (FE).
Group Config Abort Near-End (NE) node rejects the FE IMA due to Group Symmetry
error.
Gr. Insufficient Links NE finds not enough available links.
This occurs when the near end has completed parameter
negotiation with the far end, but is not passing data nor blocked.
FE Abort Symmetry FE aborted due to incompatible symmetry
FE Start Up FE is coming up (starting IMA).
FE Config Abort FE rejects the IMA from NE due to M or Group Symmetry error.
FE Insufficient Links FE node has insufficient number of links.
FE Blocked FE is not passing data.
Group Time Sync fail Far end transmit clocking mode does not match the near end
transmit clocking mode
Group Lack of Link Near end is idling because it does not have enough links in an IMA
group. This occurs only after group parameters are negotiated.
When this occurs, the "NE Insufficient Links" alarm is also reported.
IMA Protocol Mismatch IMA label is not 01.
IMA Remote Loopback Far end loopback detected, external cable loopback or crosstalk.
(continued)
Managing System Alarms 193